Download Print this page

Panasonic WV-Q122E Operating Instructions Manual page 5

Wall mount bracket

Advertisement

Rear Cable Exit
1. Preparations
Specify the bracket fixing location, and then put in
four anchor bolts (not supplied), or drill four bolt
holes on the surface.
Remember that a cable access hole is necessary on
the wall in this case.
Refer to Dimensions on page 7.
2. Rear Cable Exit
(1) Remove the rear plate, and then punch out the
cable exit on it.
(2) Fit the supplied blank bushing into the front
cable exit of the bracket.
(3) Fit the supplied cable bushing into the rear cable
exit of the plate.
(4) Replace the rear plate to the bracket fastening
four screws.
3. Cable Routing
Route the connection cables from the rear cable exit
through the bracket, and pull them out of the pipe
mouth.
4. Waterproofing
Fill the rear cable exit with sealant.
5. Fixing Bracket
Fix the bracket to the wall using appropriate hard-
ware (not supplied): bolts and nuts, anchor bolts
and nuts, or the like.
Mark hole positions
Front Cable Exit
(Not Used)
Blank Bushing
Cables
Sealant
Outside
Cable Bushing
Inside the Bracket
Fixing Hardware
(Locally Procured)
-5-
Cable Access Hole
on the wall
Rear Plate
Rear Cable Exit
Cable Bushing

Advertisement

loading