Installation; Installation Requirements; Unpacking; Location - Waldorf GP8600E Installation And Operation Manual

Installation Requirements

NOTE:
• It is most important that this appliance is installed correctly and that operation is correct
before use.
requirements.
• This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.
Waldorf Electric Griddles are designed to provide years of satisfactory service and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical and fire safety.
Australia / New Zealand
United Kingdom:
Installations must be carried out by qualified persons only. Failure to install equipment to the
relevant codes and manufacturer's specifications shown in this section will void the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only to
be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.

Unpacking

• Remove all packaging and transit protection from the appliance including all protective plastic coating
from the exterior stainless steel panels.
• Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
• Ensure that the 4 adjustable feet are securely fitted.
• Report any deficiencies to the distributor who supplied the appliance.
• Check that the available electrical supply is correct to that shown on the rating plate (Refer to the
dimension drawings for rating plate location).

Location

1. Installation must include adequate clearance and ventilation, to prevent dangerous build up of
combustion products.
2. Never directly connect a ventilation system to the appliance flue outlet.
3. Position the appliance in its approximate working position.
4. The legs (castors) must always be fitted to the base of the appliance.
5. Components having adjustments protected (e.g. paint sealed) by manufacturer are only allowed to
be adjusted by an authorised service agent. They are not to be adjusted by the installation person.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to
the appliance flue outlet.

Clearances

Left / Right Hand Side
Rear
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Installation shall comply with local electrical and health and safety
AS/NZS3000
BS 7671
Combustible Surface Non Combustible Surface
100mm
50mm
- Wiring Rules.
- Requirements for Electrical Installations.
0mm
0mm
9

Installation