General Handling Instruction; Micro-Switch; General Maintenance; Resetting The Keyboard To Factory Settings - I-Tech Bluetooth Virtual Keyboard User Manual

General Handling Instruction

Micro-switch

The device is equipped with a micro-switch which disables the Virtual
Keyboard lasers when the device is picked up. This is a safety measure. Do
not attempt to override this micro-switch.

General Maintenance

• Avoid touching the keyboard sensing receiver window.
• Never touch the keyboard projection element.
• Avoid exposing the keyboard to moisture or extreme
temperatures.
• Do not disassemble or try to touch the inside of the device.
• Do not attempt to charge the device with a different charger
than the one provided by VKB.
• If the windows become dirty clean only with a soft, lint free dry
cloth. Do not use any solvents or cleaners.

Resetting the keyboard to factory settings

• Turn the keyboard on and gently insert the end of a sharp object into
the reset hole found under the rubber flap on the right side of the
keyboard. Press for about half a second and then remove the clip.
• After about 2 seconds, the keyboard will emit a short "beep" and the
LED will flash blue.
• Pick up the keyboard and wait for it to turn off,
• Place the Virtual Keyboard back on the flat surface and turn it on.
• The Virtual Keyboard is now ready for pairing.
keyboard
Preparing the
Once the keyboard has been paired and connected to a host device, to
pair the keyboard with a different host device, turn the keyboard on, and on
the projected image press the keys
seconds. The keyboard will emit a short beep and the LED will flash blue to
indicate it is ready for pairing with another device.
to be paired with a different device
+Fn+B simultaneously for 3
19