GreenWorks GW80VSNW200 Owner's Manual page 21

MAiNTENANCE
REPLAcING THE dRIVE BELT (See Figures 10)
• Ensure that the battery is not installed in the tool.
• Remove the 5 screws (1) that secure the left side plate (2) to the frame of the snow thrower.
Remove the side cover.
• Remove the old belt (3) from the small pulley (5) and large pulley (4).
• Loop one end of the new belt over the small pulley.
• Rotate the impeller with the left hand while positioning the belt on the large pulley with the
right hand.
• install the left side cover, and secure it using the 5 screws.
1
2
21
Fig. 10