Table of Contents
Advertisement
Premium Feature—Remote Replication
The following types of Remote Replication are supported on the MD storage array:
•
Remote Replication — Standard asynchronous replication using point-in-time images to batch the
resynchronization between the local and remote site. This type of replication is supported on both Fibre Channel
and iSCSI storage arrays (not between).
•
Remote Replication (Legacy) — Synchronous (or full-write) replication that synchronizes local and remote site
data in real-time. This type of replication is supported on Fibre Channel storage arrays only.
NOTE: This chapter describes the Standard asynchronous replication premium feature only. To understand the
Remote Replication (synchronous) premium feature, see
About Asynchronous Remote Replication
Standard Remote Replication (asynchronous) is a premium feature that provides RAID controller-based data replication
between a local and remote storage array on a per-virtual disk basis. By identifying primary (local) and secondary
(remote) virtual disk pairs, called replicated pairs, write operations to the primary virtual disk of the pair are tracked by
the RAID controller firmware and captured in a point-in-time image and transferred to the secondary virtual disk in the
pair.
Remote Replication groups allow you to manage synchronization of both virtual disks to create a consistent data set
across local and remote storage arrays. Point-in-time images on the primary virtual disk and the secondary virtual disk
can be resynchronized in a batch approach that increases replication throughput. When data synchronization
completes, the system uses the point-in-time images on the secondary virtual disk to ensure that the data is maintained
in a consistent state during subsequent synchronization operations to the secondary virtual disk.
NOTE: The standard Remote Replication premium feature is supported on both iSCSI and Fibre Channel storage
arrays.
Remote Replicated Pairs And Replication Repositories
Replicated pairs, comprising of a primary and secondary virtual disk, contain identical data copies as a result of data
synchronization. Replication repository virtual disks are used to manage replication data synchronization and are
required for both the primary virtual disk and secondary virtual disk in a replicated pair.
A replication repository consists of the following types of data:
•
Resynchronization and recovery point images for both primary and secondary virtual disk.
•
Log information that tracks regions on the primary virtual disk that is written between synchronization intervals.
These logs are only used on the primary virtual disk, but are also written to the secondary virtual disk in case of
a role reversal.
•
Statistics for each replicated pair.
The replication repository is normally created automatically when you create a replicated pair. However, you can also
create the repository manually.
Premium Feature- Remote Replication
15
(Legacy).
185
Advertisement
Table of Contents
