Introduction And Machine Specifications - Clarke FA-8 Operator's Manual

Introduction & Machine Specifications
Drum
Cover
This machine was designed to supply abrasion to coated surfaces before recoating. Abrasion provides anchor sites
that promote adhesion of the new coating to the existing coating. This machine is suitable for use on factory finished
or site finished wood floors. This machine is recommended for beveled, micro beveled, and sculptured factory or
site finished wood floors. It is especially suited for use on uneven or sculpted floors where traditional methods
would otherwise damage the finish or alter the sculpting.
CAUTION:
Clarke ® American Sanders
Dust Pipe
Transport
Handle
Level
Adjustment
Model
Abrasive Size
Abrasive Rate
Operating Controls
Motor
Power Cable
Voltage/Frequency
Amperage
Dimensions (in)*
Weight (lbs)*
*Shipping Value
Your equipment may be inappropriate on some installations. Always consult with
the flooring manufacturer on the proper installation, preparation, and finishing of
their product. Determine suitability of your equipment in preparing the product.
Operator's Manual (EN) - FA-8
ENGLISH
Control Switch
Handle Latch
07166A
6" x 7½" (152mm x 190mm)
950 rpm
Lever Operated
5/8 Hp (470W) TEFC 1Ø
50' 14-3 Abrasion Resistant
115 / 60
8
21½x16x35½"
125 lbs (56.8 kg)
EN
Operating
Control Lever
Control Link
Locking Collar
- 5 -