Warning - J. A. Roby CUISINIERE Owner's Manual

Before installing, please take a few minutes to read this handbook. Keep this manual
in a sure place and easily reachable for future references. If this appliance is not properly
installed, it could cause fire damages to the property, injuries and death. To reduce fire
hazards, follow instructions contained in this handbook.
Contact an official inspector (ex: a fireman) or your insurance company for installation
permit. Always respect the provincial and municipal building codes of your region.
Do not connect this appliance to a chimney that already serves for another wood stove.
The existing chimney should be well inspected before any installation. In doubt,
consult a specialist.
Never use a non-isolated exterior conduct or a single pipe as an exterior exit.
Minimum clearances found in this manual must be observed.
Install all firebricks before lighting the stove (if it is not already done).
Never use a non-insulated exterior duct or a pipe to evacuate chimney smoke.
Do not install in a mobile house.
Keep all combustible material (clothing, furniture, wood, matches, plastic, etc) at a
distance of at least 91.5 cm (3 feet) from the appliance.
Do not use chemicals or fluids to light the fire. Never burn flammable waste or fluids
such as gasoline, naphtha or engine oil
This appliance is approved to burn wood. Do not use any other combustible.
Wood should not be stocked within the recommended minimums clearances or in the
necessary space for the loading and the ashes evacuation.
Do not burn wet or freshly cut wood. Do not use construction debris such as pieces of
2x4 or plywood.
If the appliance starts to blush, it's because it is too charged. Do not add fuel.
Immediately close the doors and the air intake of the appliance until everything becomes
normal again.

WARNING

3