Driving Your Car And Adjusting Trim; When You Finish Driving - XMODS RC Start Kit User Manual

Driving Your Car and Adjusting Trim

After you turn on both controller and car, squeeze the trigger to move forward and push the trigger
away from the handle to go in reverse.
If your car does not drive straight when you release the steering wheel, determine if the car steers
too far right or left, and then adjust the trim:
1. Turn off the controller, and then push the controller trigger forward.
2. Turn on the controller; the LED indicator on the controller flashes.
3. Keep the trigger held forward and turn the wheel to the right or left
to adjust the trim. If the car pulls to the right, turn the wheel to the
left. If the car pulls to the left, turn the wheel to the right.
4. Release the trigger; the LED indicator stops flashing and lights steadily.
• To avoid unintentionally adjusting the steering trim, do not operate
the trigger or steering wheel when you turn on the controller.
• To drive in reverse after braking, you may need to release the trigger to neutral briefly.
Running your XMODS continuously for long periods can generate high heat levels. If the car
overheats, its overheat protection will stop the car. In this case, switch the controller and the vehicle
off and allow to cool for at least 10 minutes before resuming operation.

When You Finish Driving

To conserve battery life, turn off the controller and car after you finish driving.
• Handle your XMODS car and controller carefully and do not drop them. Keep away from dust and
dirt. Wipe your car and controller with a damp cloth occasionally to keep them looking new.
• Use and store only in normal temperature environments.
8
Reverse
Neutral
Drive