Setting up the FlexFlash with Accessories Figure 3 Using SoftBoxes Installing the Modeling Lamp The FlexFlash can be used with SoftBoxes using the Photoflex The FlexFlash comes with a cover Strobe connector SC-B9017TR, which will fit all Photoflex Soft- to protect the flashtube and Boxes.
Page 4
Make sure that the tightening handle on the swivel is securely tightened to prevent unwanted tilt. Figure 7 Figure 7 For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® Visit photoflexlightingschool.com® for the best free learning resource!
Page 5
E. Audible recharge indicator on/off button L. Modeling lamp fuse holder F. Test/discharge button M. Slave sensor G. Modeling light function button For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® Visit photoflexlightingschool.com® for the best free learning resource!
Page 6
Pressing this button will discharge the unit and when you land on the by firing the flash. on the LCD display, hold it down for four seconds. For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® Visit photoflexlightingschool.com® for the best free learning resource!
Page 7
Note: Some cameras do not include a PC plug for use with sync cables, however adapters are usually available for cameras that have a hot shoe for an external flash. For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® Visit photoflexlightingschool.com® for the best free learning resource!
Need help?
Do you have a question about the FlexFlash SB–FLXFLSH400W and is the answer not in the manual?
Questions and answers