Table Of Contents - NAPCO GEMINI-P400 User Manual

Table of Contents

Keypad Controls and Indicators ........................................5
Arming your System (When Leaving) ...............................6
Protecting Yourself While Home ........................................7
Emergency Keys ...............................................................8
Disarming the System ........................................................9
Silencing an Alarm .............................................................9
Special Functions .............................................................10
System Troubles ..............................................................11
Programming User Codes ................................................13
Glossary ...........................................................................14
Important - Test Your System Weekly !
1
Bell / Battery Test
Test your bell or siren by pressing
or siren will sound for 2 seconds and the battery will also be tested.
2
Zone Test
Walk throughout the premises opening each protected door or window,
and activating each motion sensor. Check the keypad to see that each
respective zone number displays in the window.
3
Central Station Communication Test
(This test should only be performed on weekends or at a time
4
A 1
followed by . The bell
System Information
Central Station Phone Number: ________________________
Central Station Account Number: ______________________
For Service Call: ___________________________________
Entry Delay: _______________________________________
Exit Delay: ________________________________________
Alarm Time-Out: ____________________________________
designated by your alarm company)
1. Notify Central Station of the impending test.
2. Secure all zones to light Status Light on your keypad.
3. Enter your User Code followed by
4. Violate your alarm by opening a window / door etc.
5. The siren or bell should sound and the system will send the alarm
signals to the Central Station
6. Enter your User Code followed by
7. Call Central Station to insure that the alarm signals were received
properly.
Introduction
D
to Arm the system.
D
to silence the alarm.