Installation Overview - Kenwood DNX4150BT Quick Start Manual

Ñ Installation the Digital Radio antenna
(DNX4150DAB)
#CAUTION
• This film antenna is exclusively for use inside the
vehicle.
• Do not install at the following locations:
– Where it may block driver's view
– Where it may obstruct operation of safety devices
such as air bags
– On movable glass surface such as rear hatch
– On the side of the vehicle (e.g. doors, front-side
windows)
– On rear windows
• Signal strength will decrease at the following
locations:
– On IR reflecting glass or where covered with
mirror type glass film
– Where it overlaps with genuine radio antenna
(pattern)
– Where it overlaps with window heating wires
– When glass that blocks radio signals (e.g. IR
reflecting glass, thermal insulation glass) is used
• Poor reception may occur:
– Due to noise when the windshield wipers, air
conditioner, or motor is turned on
– Depending on the location of the broadcast
station in relation to the vehicle (antenna)
• Thoroughly wipe oil and dirt from the pasting
surface with the included cleaner (accessory 0).
• Do not bend or damage the film antenna (accessory
-).
• It may not be possible to install on some type of
vehicle.
• Check the cable routing of the film antenna
(accessory -) and amplifier (accessory =) before
pasting.
20
ñ English
⿠Installation overview
The antenna should be installed on the
passenger side for safety.
⿠Determining the antenna installation
location
• The direction of the film antenna (accessory
-) changes depending on whether the film
antenna is installed on the right side or left
side.
• Be sure to check the installation location
of the film antenna (accessory -) before
installing. The film antenna cannot be
reattached.
• Install the antenna at least 100 mm away
from other antennas.
• Do not attach the amplifier unit (accessory
=) to the ceramic line (black part) around
the windscreen, as it will not stick sufficiently.
When installing the antenna on the right side
Ceramic line (black part)
150 mm
Earth sheet *
- =
Antenna cable
(3.5 m)
=
30 mm
-