Saddle Opening Remote Control; Remote Control Programming - PIAGGIO X8 400 i.e. Owner's Manual

Saddle opening remote control (01_15, 01_16)

The vehicle is equipped with a key with remote control to open the saddle and the
back compartment cover from the distance. This remote control is supplied together
with the «MASTER» key and it has been programmed to control the opening device
control unit at the manufacturing stage. A maximum of 7 keys operated by remote
control can be programmed (see «remote control programming» section ). The remote
control for the black key is powered by inner batteries that get discharged after ex-
tended used; If the green LED on the handgrip turns on when the button is pressed,
the remote control is working properly.
You may need to replace the batteries inside the key if the remote control fails or if its
range of operation is reduced.
01_15
In order to carry out this operation, separate the two halves of the remote control by
inserting an edge or the thin tip of a plain slot screwdriver on the external groove and
slide it all around said groove.
Go to the printed circuit and remove the two batteries from the contact terminal; re-
place the two batteries «D», paying attention to reassemble them with the poles facing
the correct sense and with new CR1616 batteries, then reassemble the handgrip.
To open the saddle without the remote control, follow the procedure described in the
«Saddle» or «Opening saddle with remote control» section
01_16

Remote control programming

Follow these steps to program the remote controls:
1. Insert the remote control key to be programmed in the steering lock key block.
2. Turn the key to «ON», press the button on the remote control, release the button,
turn the key back to «OFF» from the «ON» position, all within 4 seconds.
3 Wait 1 to 8 seconds.
4. Repeat steps 2 and 3 for 4 times without removing the key.
18