Life Smart LS-8WIQH-DB Owners Installation And Operating Manual page 15

Heating Process:
In the High Mode, all heating elements will engage for full 1500 Watt heating capacity.
In the Low mode, corresponding heating elements will engage to heat at 750 Watts, to save
energy. This mode can be used when some heat is needed, but not at full capacity.
In the Eco mode, the heater's Set Desired Temperature will automatically default to 68°F. The
heater will determine heating element usage based on the ambient room temperature. If the
ambient room temp is below 64°F, all heating elements engage. As the ambient temperature
approaches 68°F, the number of heating elements used decreases. The heating elements will
disengage when 68°F is achieved.
The On/Off Timer: For your convenience, our heater also comes with a built in timer. This is a
function that allows for you to set the heater to Power on (to default set temp) or Power off at
desired hourly intervals.
To Set "On" Timer: With the master switch in the back of the unit "on" position, press the
"Time" button on the front control panel or remote control. The number 0 will appear on the
display. "Zero" indicates there is no specified time frame for the heater to turn on. This can be
increased in hourly increments by pressing the "time" button. The number chosen (1, 2, 3. . .9)
determines how many hours before the heater automatically turns on. After the number is set,
the display will show only the hours or minutes remaining until it automatically turns on.
To Set "Off" Timer: While the heater is heat cycling, press the "timer" button. The number 0
will appear on the display. "Zero" indicates there is no specified time frame for the heater to turn
off (it will cycle on and off based on the set desired temperature). This can be increased in
hourly increments by pressing the "time" button. The number chosen (1, 2, 3. . .9) determines
how many hours before the heater automatically turns off. The display will automatically go back
to the displaying the set desired temperature after 5 seconds of button inactivity.
The Ionizer: This heater is equipped with an Ionizer function to help purify the air in the room.
Press the "Ionizer" button location on the control panel to turn on the Ionizer, the corresponding
sign for Ionizer will display on the LCD screen. Pressing the button once again will disengage the
Ionizer.
Celsius and Fahrenheit: The heater displays temperature in Fahrenheit as the default, but has
the capability to display it in Celsius as well.
To change between °Celsius and °Fahrenheit: Press "C°/F°"
15