Wall Mounting - Abcon ProShip Instruction Manual

CLEANING
STAINLESS STEEL PLATFORM
For best results use a stainless steel cleaning spray and clean cloth.
SCALE BODY
Spray a general purpose cleaner onto a dry clean cloth and wipe scale body with cloth.
Cloth must not be dripping wet.

WALL MOUNTING

The display has a bracket fitted which can be used to wall mount the display.
1. Mark on the wall the position of where the holes need to be drilled (12.0cm apart). It is
recommended to use a spirit level / bubble level to make sure display will be level.
2. Using an appropriate drill two holes in the marked positions approximately 40mm
deep using a 6mm drill bit.
3. Insert 6mm wall plugs into the holes so that they are flush with the wall surface and
then using a screwdriver tighten 4mm diameter x 35mm long screws into the wall plug
leaving only @3-4mm of the screw protruding out of the wall.
4. Align the holes on the display bracket over screws and push bracket towards the wall
so that the screws go through the holes. Then release the bracket so that the display
is now sitting on screws and tighten the screws so that the bracket will not move from
this position.
14 PROSHIP
®
12.0cm