Abcon ProShip Instruction Manual page 10

CALIBRATION
3. Press [ZERO], the display will now say "CAL" and then a 5 digit number which is a
special internal reference number. The last number(s) on the right will change up or
down slowly. When these numbers are hardly changing and/or the stable indicator is
showing press [UNIT]. The display will now flash "- - - - -" for a second and then flash
with the weight you entered.
• Place the item(s) to be used for calibration on the platform, wait for a moment and
then press [UNIT]. Another 5 digit number will appear on the display which you DO
NOT need to worry about.
• Press [ON/OFF] to turn scale off to complete and save the calibration.
If a mistake has been made, pressing [ON/OFF] before the end of step 3, will turn the
scale off and calibration will not have taken place.
To test the calibration was successful, turn on the scale by pressing [ON/OFF], once the
scale has finished self testing and the display shows 0, put item(s) used for calibration on
the platform and check the scale is weighing correctly. If not, repeat steps 2 & 3 again.
10 PROSHIP
®