Table of Contents
Advertisement
Installation
1 Antenna Connection (Cable Box, and VCR)
Use this configuration when connecting
Connect the cable from
the Output terminal on
the back of the VCR to
the Antenna
input
terminal on the left side
of the TV.
the TV to a cable TV system using a Cable Box
and
VCR.
CABLE BOX
ANTENNA
TERMINALS ON
THE LEFT SIDE
OF THE TV
A,.+.-..,.
:.....a a+ +rrrm:r
I
TO VCR
System
'om
TV
Note: When the antenna cable is connected to the TV antenna terminal via a cable box or VCR, set the TV channel
to CH3 or CH4, cable. This does not apply when signal is input from VIDEO INPUT.
Removing stand cover
Installation Options
Installing
on a Wall
l
For reasons of performance and safety, installation using the optional wall-mount
bracket should only be attempted by a qualified installer.
l
Keep the Installation Manual and all the removed parts in a safe place for future use.
Example of
Wall-Mount Installation
installation
Option
Wall-mount bracket (model No.: TY-WK15TA2U)
If you require further information, contact the dealer where you purchased this product.
Installing
/ Removing the Stand Cover
l
The optional wall-mount bracket can be installed only after
1.
Removing the Stand Cover
@I Release the lock in the
the TV stand is removed. Follow the instructions below to
lower center of the stand
remove the stand cover.
cover.
l
Once wall mount has been mounted, replace stand cover.
@ Slowly pull the cover
l
For detailed TV stand installation/removal
steps, refer to
downward.
the installation manual for the wall-mount bracket
(optional).
2. Installing the Stand Cover
a> @I Insert the 3 upper claws
of the stand cover into
the mating slots.
@I Press in the lower center
of the stand cover.
9
Advertisement
Table of Contents
