ZyXEL Communications ZyAIR G-3000 Quick Start Manual page 19

PROBLEM
The SYS LED is Unplug the power adaptor and plug it in again. If the error persists, you may have a
off. hardware problem. In this case, you should contact your vendor.
I cannot ping any If the ETHN LED is off, check the cables between the ZyAIR and your computer or
computer on the hub.
wireless LAN.
Verify that the IP address and the subnet mask of the ZyAIR and the computers are
in the same range.
ZyAIR G-3000 Quick Start Guide
CORRECTIVE ACTION
19