U
s
e
r
M
a
n
u
a
l
U
s
e
r
M
a
n
u
a
l
5.1.8 Can't access IP camera in internet
There are some reasons:
1 ActiveX controller is not installed correctly
2 The port which camera used is blocked by Firewall or Anti-virus software. Please change another port
number and try again. (Figure6.7)
3 Port forwarding is not successful(Figure4.30)
Check these settings and make sure they are correct.
5.1.9 UPnP always failed
UPnP only contains port forwarding in our recent software. Sometimes, it may be failed to do port forwarding
automatically because of firewall or anti-virus software. It also has much relation with router's security settings.
So we recommend you do port forwarding manually. You can view your camera in internet successfully after
you do port forwarding manually in your router.
5.1.10 Camera can not connect wireless
If your camera could not connect wireless after you set wireless settings and plug out the cable. Please check
whether your settings are correct or not.
Normally, camera can't connect wireless mainly because of wrong settings.
Make sure broadcast your SSID; use the same encryption for router and camera.
5.1.11 Remove the plug-in
Remove the plug-in from IE
If you need to remove the plug-in from IE, please open an IE page.
Go to Tools-->Manage Add-ons-->Show All add-ons-->then find the ocxIPcam Control, double click to remove
it.
Camera will prompt you to install the latest one when next logging.
(Do not login your camera during the deleting, or the plug-in won't removed caused it is running.)
79