U
s
e
r
M
a
n
u
a
l
U
s
e
r
M
a
n
u
a
l
If you replace the lens, the image has found distortion, uneven and so on, you can modify the Select The
Distortion Correction Parameter to calibration images.
4.5 Alarm
4.5.1 Motion Detection
IP Camera supports Motion Detection Alarm, when the motion has been detected, it will send emails or
upload images to FTP.
To enable motion detection, follow the steps below:
1 Enable Motion detection
2 Sensitivity---- It supports three modes: Low, Middle and High. The higher the sensitivity, the camera will be
more easily alarmed. Select one motion sensitivity.
3 Trigger interval--- The interval time between two motion detections. Here supports
5s/6s/7s/8s/9s/10s/11s/12s/13s/14s/15s. Select one interval time.
4 Select the alarm indicators
When the motion has been detected, the alarm status will turn to Detect alarm.
Figure 4.45
63