Setting the Clock
The MC-10A Remote Interface Controller features an
electronic clock for your convenience. The clock may be
configured for either 12 hour or 24 hour time mode display.
►
Access the Clock Menu by holding down the Clock
Button [7] for 10 seconds.
25
24
AM/PM
If configured for 12 hour time mode, select either AM or PM.
25
Hours
Select the current hour.
26
Minutes
Select the current minute.
►
While in the Clock Menu, use the Increase Button [3]
and Decrease Button [4] to make your menu
selections. The parameter to be configured will blink
until your selection is acknowledged. Using the Clock
Button [7], acknowledge your selection and proceed to
the next parameter.
-13-
24
26