Advanced Operation; Selection Of The Camera (Id Of The Camera); Selection Of The Dvr (Id Of The Dvr); Key Description Of The Controller - Nuvico EasyTrack CK-1000 Instruction Manual

4. ADVANCED OPERATION

4.1 Selection of the Camera (ID of the Camera)

There are three ways for dome camera selection
selections, the keyboard controller has the full control of the selected dome camera.

4.2 Selection of the DVR (ID of the DVR)

A DVR must be selected before being controlled by the joystick controller.
Press Numeric button, then press
<Ex 1> Select DVR ID #3
Press numeric
displayed on the LCD window.
<Ex 2> Select DVR ID # 73
Press and
7

4.3 Key Description of the Controller

Function Key Buttons
Numeric
0 , 1
CAM SEL
ESC
Alarm
ON
OFF
Home
Preset
Tour
Pattern
Auto Scan
button to change DVR ID to be controlled.
DVR
DVR
then button on the controller, DVR-003 will be
3
then button, DVR-073 will be displayed on the LCD window.
DVR
3
Camera ID selection with CAM SEL key.
Function number selection with function keys.
~ 9
(e.g., 1+CAM SEL, 3+Tour, 5+Scan, 6+Prst)
Select camera ID (address).
Exits from currently running functions or menu, error status, etc.
ESC
Disregards all currently activated alarms and turns off the beep temporarily. If
alarm is activated again within the programmed hold time, the timer will restart
and beep again.
Relay No. 1~4+ ON will activate the selected relay.
Relay No. 1~4+ OFF will disable the selected relay.
Immediately calls Home function.
Deletes selected value or function in programming mode
Pressing Preset will bring up the preset programming menu.
Recalls preset; e.g.; 1, 2... 31... 240 +
In the preset or tour programming mode, the operator can review the existing
preset (selected by cursor) by pressing this key.
Pressing Tour will bring up the tour programming menu directly.
Recalls programmed presets or functions sequentially. Ex) 1 ~ 8+
Pressing Pattern will bring up the pattern programming menu directly.
Repeats the selected pattern of the current dome camera. Ex) 1 ~ 4+
Pressing Scan will bring up the Auto Scan programming menu.
Calls Auto panning function. ex) 2+
,
and (Next) or (Prev)
1 ,
Description
(Scan) -- repeats Auto Scan 2.
CONTROLLER KEYBOARD
. With these
(Preset)
(Tour)
(Pattern)
24