Installing The Child Restraint Using The Vehicle Seat Belts - Jeep Grand Cherokee 2011 User Manual

• All three rear seating positions have lower anchorages that are capable of
accommodating LATCH-compatible child seats having flexible, webbing-
mounted lower attachments.
• Child seats with fixed lower attachments must be installed in the outboard
positions only.
• Never install LATCH-compatible child seats such that two seats share a
common lower anchorage.
• Attach the lower hooks or connectors over the top of the anchorage bars,
pushing aside the seat cover material. The rear seat lower anchorages are
round bars, located at the rear of the seat cushion where it meets the
seatback. The rear seat lower anchors can be readily identified by the
symbol located on the seatback directly above the anchorages and are just
visible when you lean into the rear seat to install the child restraint.
• The tether strap should be attached to the tether anchor on the rear of the
seatback (behind the gap panel) using the most direct path. DO NOT USE the
cargo tie down loops located on the load floor.

Installing The Child Restraint Using The Vehicle Seat Belts

• To install a child restraint, first pull enough of the seat belt webbing from the
retractor to route it through the belt path of the child restraint and slide the seat
belt latch plate into the buckle.
GETTING STARTED
• Loosen the child seat adjusters on
the lower straps and tether straps so
that you can attach the hook or
connector to the lower tether
anchorages more easily.
• Tighten all three straps as you push
the child restraint rearward and
downward into the seat.
15