Theft Alarm - Jeep Grand Cherokee 2011 User Manual

GETTING STARTED
• Press the ENGINE START/STOP button a second time to change the ignition
switch to the ON/RUN position.
• Press the ENGINE START/STOP button a third time to return the ignition switch
to the OFF position.
ACC
Press
OFF
Press

THEFT ALARM

To Arm
• Keyless Enter-N-Go button installed: Press the Keyless Enter-N-Go
Start/Stop button until the Electronic Vehicle Information Center (EVIC)
indicates that the vehicle ignition is "OFF." Press the power door lock switch
while the door is open, press the Key Fob LOCK button, or with one of the Key
Fobs located outside the vehicle and within 5 ft (1.5m) of the driver's and
passenger front door handles, press the Keyless Enter-N-Go LOCK button
located on the door handle.
• Keyless Enter-N-Go button not installed: Turn the ignition switch to the
"OFF' position. Press the power door lock switch while the door is open, press
the Key Fob LOCK button, or with one of the Key Fobs located outside the
vehicle and within 5 ft (1.5m) of the driver's and passenger front door handles,
press the Keyless Enter-N-Go LOCK button located on the door handle.
NOTE: After pressing the Keyless Enter-N-Go LOCK button, you must wait
2 seconds before you can lock or unlock the vehicle via the door handle.
To Disarm
• Keyless Enter-N-Go button installed: Press the Key Fob UNLOCK button or
with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of
the driver's and passenger front door handles, grab the Keyless Enter-N-Go
door handle and enter the vehicle, then press the Keyless Enter-N-Go
Start/Stop button (requires at least one valid Key Fob in the vehicle).
• Keyless Enter-N-Go button not installed: Press the Key Fob UNLOCK
button or with one of the Key Fobs located outside the vehicle and within 5 ft
(1.5m) of the driver's and passenger front door handles, grab the Keyless
Enter-N-Go door handle and enter the vehicle, then turn the ignition to the
ON/RUN position.
12
NOTE: If the ignition switch is left in the
Press
ACC or ON/RUN (engine not running)
RUN
position and the transmission is in PARK,
the system will automatically time out
after 30 minutes of inactivity and the
ignition will switch to the OFF position.