Existing Construction - Quirky ISO Manual

9 Pinch second mounting spring and give the ceiling panel
a slight push to click into place. Ceiling panel should be
mounted flush against the ceiling.
10 Push bell into center of ceiling panel to install. Give it a slight
tug to make sure it does not pop off. It should be able to
rotate freely.
11 Carefully install two (2) 13W (60W equivalent) GU24 CFL
bulbs (not included) into the sockets and one (1) 7W C7
incandescent bulb (not included) into the black center socket.
12 Attach metal trim glass dish to bell with the four (4) short
machine screws (provided).
Hardware used: Short machine screws x 4
13 Turn on electricity at breaker box after completing installation.
|
ISO 10

EXISTING CONSTRUCTION

1 Remove existing fan and fan housing.
2 Make sure the existing hole is at least 10" x 10"
(25.4 cm x 25.4 cm) but smaller than 13" x 13" (33 cm x 33 cm).
3 Cut into the ceiling (about 2" [5 cm] wide to fit drill bit – refer
to diagram) to extend suspension brackets and mount to stud
(use a stud finder if necessary).
NOTE: Save drywall piece to patch holes cut for suspension
brackets after completing step 4 in New Construction.
10"
HOLE FOR FAN
JOIST
2"
4 Refer to Steps 2–13 in "New Construction" to
complete installation.
10"
JOIST
2"