Replacing The Lamp - Casio XJ-S43W User Manual

Replacing the Lamp

During normal use, the lamp and the area around it become extremely
hot. Before replacing the lamp, turn off the projector and wait for the
cool down operation (indicated when the POWER/STANDBY indicator is
flashing amber) to finish. Next, disconnect the AC power cord from the
projector, and wait for at least 60 minutes to allow it to cool down
even further.
Touching the lamp or the area around it during operation or
immediately after turning off the projector creates the risk of serious
burn injury.
Replace the lamp using the optional lamp cartridge only.
XJ-S43W Replacement Lamp YL-4B
A mercury lamp with high internal pressure is used as the light
source. A lamp that is weakened by impact, damage, or expiration of
its lamp life may explode or fail to light if exposed to loud noise. Note
Caution
that lamp life differs greatly from lamp to lamp, and is affected by
conditions under which the lamp is used.
Never touch the glass of the lamp with your fingers. Doing so can
cause the lamp to rupture and shorten its life.
A broken lamp can cause glass fragments to be scattered inside the
lamp housing. Gas inside of the lamp housing may also be discharged
from the projector's vent exhaust ports. Gas inside of the lamp
includes mercury, so be sure to ventilate the area whenever the lamp
breaks. Should you accidentally inhale gas fumes or should gas fumes
get into your eyes, immediately contact a physician.
Should the lamp break, take care to avoid personal injury on the glass
fragments. Never try to replace a broken lamp on your own. Be sure
to contact your original dealer or authorized CASIO service center to
request replacement.
The lamp contains mercury. Dispose of old lamps in accordance with
the rules and regulations of your local jurisdiction.
Downloaded From projector-manual.com Casio Manuals
38