Configure The Dvr For Access On Your Home Network - H.264 DVR9004N Installation And Setup Manual

SECTION 4: NETWORKING YOUR DVR
vary widely. However, the documentation provided with your router, with the general guidelines included here, should enable you
to setup your DVR for web access.

4.1 Configure the DVR for access on your home network

To setup your DVR on the network without conflicting with other devices, configure the network settings of your DVR before
physically connecting it to the network. Network conflicts occur when two devices on the network have the same IP address. The
screens shown here were taken from a Windows XP system:
1. Determine the IP address, subnet mask, and default gateway of your home computer (PC) and record it in Table 1. To get this
information, do the following at the Windows desktop:
a. Open the Windows Start menu and click Run to open the Run dialog box.
b. Type cmd in the entry field and then click OK to open the DOS command window.
c. At the command prompt, enter ipconfig. The PC will display Ethernet data associated with your Ethernet adapter local
area network (LAN) connection.
d. Enter the IP Address, Subnet Mask, and Default Gateway for your PC's Ethernet adapter into Table 1.
34
Example: Typical use of ipconfig in Windows XP