DeVilbiss ATK90 Operator's Manual page 9

To use:
Turn air compressor on and allow air tank to fill.
l
Set the air compressor's regulator to 90 PSI. This tool operates at a
l
maximum 90 PSI pressure.
Place tool in forward or reverse position.
l
Depress the throttle control lever to operate tool. NOTE: The throttle
l
control lever provides instant response when depressed.
Release throttle control lever to stop tool.
l
Always disconnect air supply when changing sockets.
l
When job is complete, turn the air compressor off and store as described
l
in the air compressor operator manual.
Tips
Drive the fastener until the ratchet stalls and then further tighten by
l
operating the air ratchet in the same manner as a manually operated
ratchet.
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and
bearing uses compressed air to power the tool. Because moisture in
compressed air will rust the air motor, you must lubricate the motor daily. An
inline oiler is recommended.
To lubricate the air motor manually:
Disconnect the tool from the air supply holding it so the
l
air inlet faces up.
Depress throttle control lever and place one to two
l
drops of air tool oil in the air inlet Depressing the
throttle control lever helps circulate oil in the motor.
NOTE: Use SAE #10 weight oil if air tool oil is not
available.
doctor immediately or contact your local poison control center.
Connect the tool to an air source, cover the exhaust end with a towel and
l
run for a few seconds.
exhaust port away from people or objects.
MAINTENANCE
Keep out of the reach of children. If taken
internally, do not induce vomiting, call a
Any excess oil in the motor is immediately
expelled from the exhaust port. Always direct
Failure to lubricate the tool at the air inlet will
void your warranty.
9- ENG
D24152