Side Handle - DeWalt DW138 Instruction Manual

DW138/DW139/384347-01 rev
terminal. If your unit is intended for use on less than 150 V, it has a plug
that looks like that shown in sketch A. If it is for use on 150 to 250 V, it
has a plug that looks like that shown in sketch D. An adapter, sketches
B and C, is available for connecting sketch A type plugs to 2-prong
receptacles. The green-colored rigid ear, lug, or the like, extending
from the adapter must be connected to a permanent ground, such as
a properly grounded outlet box. No adapter is available for a plug as
shown in sketch D. ADAPTER SHOWN IN FIGURES B and C IS NOT
FOR USE IN CANADA.
A GROUNDED
OUTLET
BOX
GROUNDING PIN
SAVE THESE INSTRUCTIONS
Motor
Your D WALT tool is powered by a D
E
power supply agrees with the nameplate marking. The markings; 120
volts, 50/60 Hz or "AC/DC", mean that your drill will operate on
alternating or direct current.Voltage decrease of more than 10% will
cause loss of power and overheating. All D
tested; if this tool does not operate, check the power supply.

Side Handle

To install the side handle, use the metal plate, four screws and four
lock washers included with the unit. Install the plate with the screws
as shown in Figure 1. Tighten all screws securely. Screw the
threaded end of the side handle into the plate and tighten securely.
8/2/2002 9:20 AM Page 2
B C
GROUNDING
MEANS
ADAPTER
WALT built motor. Be sure your
E
WALT tools are factory
E
Figure I.2: The NDA Review and Approval Process
FIG. 1
FIG. 2
SPADE HANDLE
SIDE HANDLE
CHUCK
TRIGGER LOCK
BUTTON
INSPECTION
TRIGGER
SWITCH
2
SIDE
HANDLE
SCREWS
(PROVIDED)
LOCK
WASHER
METAL
PLATE
FIG. 3
RAISED INDICATOR
BRUSH
REVERSING
RING
CAP