Side Handle - DeWalt DW505 Instruction Manual

• Hammer bits and tools get hot during operation. Wear gloves
when touching them.
CAUTION: DO NOT TOUCH ANY METAL PARTS OF THE TOOL
when drilling or driving into walls, floors or wherever live electrical
wires may be encountered! Hold the tool only by insulated grasping
surfaces to prevent electric shock if you drill or drive into a live wire.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
CAUTION: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this product
may contribute to hearing loss.
The label on your tool may include the following symbols.
•
V ....................volts
Hz ..................hertz
min ..................minutes
..................direct current
A..............amperes
W ............watts
............alternating current
n o ............no load speed
....................Class II
........................Construction
BPM ................beats per minute

Side Handle

CAUTION: Always use side
handle when provided and hold
hammerdrill with both hands.
A side handle is supplied with this
hammerdrill. It clamps to the front of
the gear case as shown in Figure 1
and can be rotated 360˚ to permit
right or left hand use.
Switch
To start hammerdrill, depress the trigger switch (Figure 2). To stop
hammerdrill, release the switch. To lock the trigger switch in the ON
position for continuous operation, depress the trigger switch and push
up the locking button . The tool will continue to run. To turn the tool
FIGURE 2
REVERSING
LEVER
TRIGGER
SWITCH
LOCKING
BUTTON
3
.../min ......revolutions or
................reciprocation per
................minute
FIGURE 1