Access From The Internet; Setting The Admin Password Over A Secure Connection; Live View Page - Xineron XIN-MPD-0110 Quick Installation Manual

Table of Contents

Quick Installation Guide

3.2. Access from the internet

Access from the internet once connected, the Network Camera is accessible on your local network

(LAN). To access the network camera from the Internet you must configure your broadband router to

allow incoming data traffic to the network camera. To do this, enable the NAT-traversal feature, which

will attempt to automatically configure the router to allow access to the network camera. This is

enabled from Setup > System > Network > NAT.

For more information, please see "3.5.4 System>Network>NAT" of User's Manual.

To gain access to the product, the password for

the default administrator user must be set. This

is done in the "Admin Password" dialog, which is

displayed when the network

is accessed

camera

for the setup at the first time. Enter your admin

name and password, set by the administrator.

Note: The default administrator username and

password is "admin". If the password is lost, the

Network Camera must be reset to the factory

default settings. See "3.8 Resetting to the

Factory Default Settings".

The live view page comes in seven screen modes: 19206x1080, 1280x1024, 1280x720,

720x480(576), 640x480, 352x240(288) and 320x240. Users are allowed to select the most

suitable one out of those modes. Please, adjust the mode in accordance with your PC

specifications and monitoring purposes.

Table of Contents