Exposure - Photon Focus MV1-D1312C CameraLink Series User Manual

7 Graphical User Interface (GUI)

7.1.1 Exposure

This tab contains exposure settings.
Figure 7.2: MV1-D1312C-160 exposure panel
Exposure
Exposure time [ms :] Configure the exposure time in milliseconds.
Constant Frame Rate: When the Constant Frame Rate (CFR) is switched on, the frame rate
(number of frames per second) can be varied from almost 0 up to the maximum frame
rate. Thus, fewer images can be acquired than would otherwise be possible. When
Constant Frame Rate is switched off, the camera delivers images as fast as possible,
depending on the exposure time and the read-out time.
Frame time [ms :] Configure the frame time in milliseconds. Only available if Constant Frame
Rate is enabled. The minimum frame time depends on the exposure time and readout
time.
Simultaneous readout (Interleave)
The simultaneous readout mode allows higher frame rate.
Simultaneous readout (Interleave): Enable the simultaneous readout mode.
Combination of property Trigger.Interleave and property LinLog.Mode is
not available!
Trigger.LevelControlled is not available!
ger.Interleave and property Trigger.EnBurstTrigger is not available!
70
Combination of property Trigger.Interleave and property
Combination of property Trig-