Rgb Bayer Pattern Filter; Frame Grabber Relevant Configuration - Photon Focus MV1-D1312C CameraLink Series User Manual

3 Product Specification
Exposure Time
Exposure time increment
Frame rate
Pixel clock frequency
Pixel clock cycle
Camera taps
Read out mode
Table 3.3: Model-specific parameters (Footnote:
Operating temperature
Camera power supply
Trigger signal input range
Max. power consumption
Lens mount
Dimensions
Mass
Conformity
Table 3.4: Physical characteristics and operating ranges
Fig. 3.2 shows the quantum efficiency and Fig. 3.3 the responsivity of the A1312C CMOS sensor,
displayed as a function of wavelength. For more information on photometric and radiometric
measurements see the Photonfocus application notes AN006 and AN008 available in the
support area of our website www.photonfocus.com.
The A1312C colour sensor is equipped with a cover glass. It incorporates an infra-red cut-off
filter to avoid false colours arising when an infra-red component is present in the illumination.
Fig. 3.4 shows the transmssion curve of the cut-off filter.

3.4 RGB Bayer Pattern Filter

Fig. 3.5 shows the bayer filter arrangement on the pixel matrix in the MV1-D1312C camera
series. The numbers in the figure represents pixel position x, pixel position y.
The fix bayer pattern arrangement has to be considered when the ROI configu-
ration is changed or the MROI feature is used (see 4.3). It depends on the line
number in which an ROI starts. An ROI can start at an even or an odd line num-
ber.
3.5 Frame Grabber relevant Configuration
The parameters and settings, which are essential to configure the frame grabber are shown in
the following table. The timing diagrams of the camera are given in Section 4.1.2.
16
3)
( T = 10 µs)
int
sequential or simultaneous
3)
Maximum frame rate @ full resolution)
C-Mount (CS-Mount optional)
MV1-D1312C-160
10 µs ... 0.42 s
25 ns
108 fps
80 MHz
12.5 ns
2
MV1-D1312C-160
0°C ... 50°C
+12 V DC (± 10 %)
+5 .. +15 V DC
< 3.5 W
3
60 x 60 x 45 mm
265 g
CE / RoHS / WEE