Support For Association Groups - Z-Wave ZTS-110 User Manual

Step Procedure / Description
Gateway / Controller device should be set
to inclusion mode.
Press and hold "Home" key for 2 seconds
1
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
Press "Prog" key once, it will search the
2
network.
If the ZTS-110 is added into the network
3 successfully, the signal of "done" will
appear.
Press "Home" key once to go back to the
home page.
4
will appear on the main display.
Note:
- It is recommended to perform the Delete/Exclude procedure before doing
Add/Include. This is to make sure the ZTS-110 is not in any other Z-Wave
network which will result in failure in Inclusion process.
- If the inclusion is failed, try exclusion, and/or reset ZTS-110 to factory default and
try inclusion again.
- After ZTS-110 is included to Z-Wave network, it will stay in Easy mode by default.
- You can enable or disable Easy mode by local "Setting Mode" or Z-Wave
parameter number 8.
(please refer to parameter table at Z-Wave Configuration Parameters).
LCD indication
MO WAKE
AM
PROG ON
FAN AUTO
29
Delete (Exclude) ZTS-110 from Gateway / Controller Z-Wave
network
Step Procedure / Description
Gateway / Controller device should be set to
Exclusion mode.
Press and hold "Home" key for 2 seconds
1
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
Press "Prog" key once, it will search the
2
network.
If the ZTS-110 is removed from the network,
it shows no connection. Exclusion is
3
completed.
COOL
Press "Home" key once to go back to the
home page.
4
will appear on the main display.
Support Association Groups (Association Command Class)
ZTS-110 supports 3 association groups.
Association group
Mode
Heating mode
Cooling mode
OFF
LCD indication
MO WAKE
AM
PROG ON
FAN AUTO
Association group_1
Association group_2
(Heat pump) (Compressor)
ON
(basic set command 0xFF) (basic set command 0x00)
OFF
(basic set command 0x00) (basic set command 0xFF)
OFF
(basic set command 0x00) (basic set command 0x00)
30
OFF
OFF
ON
OFF