Controls And Machine Parts; Control Panel Description; Unpacking/Installation; Power Supply Connection - Saeco SUP 015 User's And Maintenance Booklet

13
IMPORTANT SAFEGUARDS
a) A short power-supply cord (or detachable power-supply cord) is to be provided to
reduce risks resulting from becoming entangled in or tripping over a longer cord.
b) Longer detachable power-supply cords or extension cords are available and may be
used if care is exercised in their use.
c) If a long detachable power-supply cord or extension cords is used,
1) The marked electrical rating of the detachable power-supply cord or extension cord
should be at least as great as the electrical rating of the appliance,
2) If the appliance is of the grounded type, the extension cord should be a grounding-
type 3-wire cord, and
3) The longer cord should be arranged so that it will not drape over the counter top or
table top where it can be pulled on by children or tripped over.
1 Coffee grounds container
2 Drip tray
3 Cup holder surface
4 Main switch
5 Power cord
6 Coffee dispensing unit
7 Steam/hot water dispensing tube with heat
protector
8 Control panel
9 Steam/hot water selection knob
10 Heating plate for cups
11 Water tank
12 Water tank cover

Control panel description

Digitaldisplay-Anzeige
Digital display
Standby-Schalter
Standby switch
Ein/Aus Energiesparmodus
Standby mode on/off
Starttaste 1 bzw. 2 Tasse/n Kaffee lang
Selection key for 1 or 2 cups of tall coffee or key
oder Pfeiltaste « » im Programmiermodus
<< >> in the programming mode
Starttaste 1 bzw. 2 Tasse/n Kaffee
Selection key for 1 or 2 cups of regular coffee
oder Pfeiltaste « » im Programmiermodus
or key << >> in the programming mode
Starttaste 1 bzw. 2 Tasse/n Kaffee Espresso
Selection key for 1 or 2 cups of espresso coffee or key <<ESC>> in the programming
oder « »-Taste im Programmiermodus
mode
Taste zur Anwahl Kaffeepulver oder « »-Taste im Programmiermodus
Pre-ground coffee selection button or key <<ENT>> in the programming mode
Steam selection button Taste zum Ein-/Ausschalten des Dampfes

CONTROLS AND MACHINE PARTS

13 Water level
14 Pre-ground coffee container with cover
15 Coffee bean container cover
16 Coffee bean container
17 Grind adjustment lever
18 Coffee dosage adjustment lever
19 Service door
20 Filling funnel
21 Handle for assembling and disassembling
of central unit
22 Central unit
23 Coffee rest drawer
24 Swivel
"WARMING UP"......
Aufheizen...
14

Unpacking/Installation

Standard packing is strong enough to protect
the machine during mail shipping. Keep this
package to return the machine to the manufac-
turer should it be necessary.
Before installing the machine, keep to the
following safety indications:
Position the machine in a safe place.
Do not allow children to play with the machine.
Make sure the machine is not placed nearby hot
surfaces or open flames.
Always use the machine with the swivel (24).
Thus, when installing the machine, make sure to
rest it directly on this support by inserting it into
the slot on the lower side of the machine.
Now the machine is ready to be connected.

Power supply connection

Warning: electric current may cause death!
The coffee machine must be connected to an
adequate socket. Voltage must suit to the volt-
age specified on the appliance rating plate.
Never use defective power cords.
Defective power cords and plugs must be
replaced by authorised personnel.
UNPACKING/INSTALLATION
Should an extension cord be used, check its
perfect condition. The extension cord must have
a minimum section of 1,5 mm 2 or 16 AWG and
must be supplied with a three-pole plug/socket.

Starting and use

Danger!
Electric voltage may cause death!
Parts under current shall never be in
contact with water: danger of short-
circuit! Overheated steam and hot
water may cause burns. Do not direct
steam or water jet towards the body;
furthermore, great attention must be
given when touching either the dis-
pensing tube or the heating plate:
danger of burns!
For your own safety as well as for
other people's safety, keep to the
safety precautions described (see
page 11).
Never use the machine without water or coffee
beans.
Remove measuring spoon, brush and the cen-
tral unit key from the coffee grounds container
(1) and keep them within reach.
Unwind the power cord (5) from the rear side of
the machine.
25
The bean coffee container (16) is attached with
two screws. Remove the cover (15) and fill it
with coffee beans (approx. 300 g), then re-
place the cover.
Adjust grinding by means of the grind adjust-
ment lever (17), positioning it on point 5 of the
scale.