DeWalt DWE4010 Instruction Manual page 37

5. Press the spindle lock (B) and rotate the spindle (K) until it locks
in position.
6. Tighten the threaded clamp nut (N) with the two-pin spanner
supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (N) with the two-pin
spanner.
WARNING: Do not use a damaged disc.
FIG. 5A
FIG. 5B
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without the use of
the spacer and threaded flange.
Fitting and Removing a Backing
Pad/Sanding Sheet (fi g. 1, 6)
The backing pad is available at extra cost from your local dealer or
authorized service center.
1. Remove the guard from
the tool.
2. Remove the backing flange
(J).
N
3. Place the rubber backing
L
pad (O) correctly onto the
J
spindle (K).
K
4. Place the sanding sheet (P)
on the rubber backing pad.
5. Screw the threaded clamp
nut (Q) onto the spindle (K).
6. Press the spindle lock
button (B) and rotate the
spindle (K) until it locks in
position.
N
7. Tighten
L
clamp nut (Q) with the two-pin spanner.
J
8. Release the spindle lock
K
9. To remove the rubber backing pad, loosen the threaded clamp
nut (Q) wih the two-pin spanner.
35
FIG. 6
O
K
the threaded
Q
P