Engine Restart - Indmar 5.7L Vortec Operator's Manual

Hide thumbs Also See for Indmar 5.7L Vortec:
Table of Contents

Advertisement

1
Figure 3.4 – Typical Shift/Throttle Lever
3. Disengage the shift interlock. Advance throttle lever
to full throttle position and hold. Hold key in START
position for no more than 10 seconds to clear extra
gasoline from the engine. When engine starts, imme-
diately return throttle handle to IDLE position.
4. If it does not start, wait two minutes and try the
sequence again.
3-4

ENGINE RESTART

2
1. If your engine is already warm and will not re-start,
2. Make sure that your throttle lever is in NEUTRAL.
3. Turn key OFF. Try to start engine again. If it does
INDM-A016
sories, you could change fuel injection controls for
your engine or could exceed the amperage capacity
of the wiring and protection system. Before adding
electrical equipment, consult your Indmar dealer.
turn key to ON position and wait for about 20 sec-
onds (not necessary with carbureted engine).
not start disengage the shift interlock and advance
throttle to about 1/4 while holding key in the START
position. (Remember, you should only hold key in
start position for 12 seconds at a time.) When engine
starts, release the key and immediately return throttle
to IDLE position.
NOTICE
Your engine is designed to work with the
standard electronics installed in your boat. If
you add electrical components or acces-
Indmar Marine Engines

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents