Indmar 5.7L Vortec Operator's Manual page 23

8. Back trailer into the water. Make sure the engine
water intake is submerged.
!
Before starting engine operate bilge blower
at least 4 minutes and raise engine cover to
ventilate fumes. Inspect engine and compart-
ment for any fluid or fuel leaks. Failure to do
so can possibly result in fire and/or explo-
sion resulting in death or serious injury to
you and your passengers.
Figure 1.4 – Raised Engine Cover
Indmar Marine Engines
!
EFI engine for the first time.
This allows the electric fuel
pump to fill the fuel injection
lines with gasoline. Each
time you advance the ignition
switch to the "ON" position,
the fuel pump cycles for 2
seconds.
9. EFI Engines Only. Prime the fuel system by cycling
NOTICE
Priming the EFI Fuel
System is required
before starting your
NOTICE
Priming fuel system
is not necessary with
carbureted engines.
the fuel pump eight to ten times before the engine is
started for the first time. To prime:
• Turn the ignition key ON for 5 seconds.
• Turn the ignition key OFF for 5 seconds.
• Repeat above eight to ten times
ON
OFF
START
ACC
INDM-A006
Figure 1.5 – Engine
"On" Switch
1-3