Removal And Installation Of Wheels; To Change Spacing Between The Fence And Vise; Depth Stop; Trigger Switch - DeWalt D28720 Instruction Manual

FIG. 5
Q
F
R
E

TO CHANGE SPACING BETWEEN THE FENCE AND VISE

Using the wrench provided, loosen and remove the two fence bolts
(Q). Adjust the fence (E) to desired locations. Insert both fence bolts
in provided locations. Securely tighten both fence bolts before use.
Depth Stop (Fig. 1)
Depth stop is set at the factory for a new 14" (355 mm) wheel to
prevent wheel from cutting into the supporting surface. To allow more
depth of cut, use the flat wrench provided (G) to loosen the depth
stop bolt (M) and raise bolt to desired height and then turn jam nut
(P) clockwise until seated firmly on the casting. Securely tighten the
depth stop bolt before use.
CAUTION: When changing to a new wheel, readjust depth stop to
original position to prevent cutting into supporting surface.
Trigger Switch (Fig. 1)
To start the tool, depress the trigger switch (N). To turn the tool off,
release the trigger switch. Keep hands and material from wheel until
it has coasted to a stop.
To prevent unauthorized use of tool, install a standard padlock (not
included) into the padlock hole (O) located in the trigger.
FIG. 6
Q
E
D
R

Removal and Installation of Wheels

(Fig. 1, 7, 8)
CAUTION: Turn off and unplug the tool before making
any adjustments or removing or installing attachments or
accessories. Be sure the trigger switch is in the OFF position.
Do not make any adjustment while the wheel is in motion.
Do not make any adjustment while chop saw is plugged into
power supply.
1. Push in wheel lock lever (L) and rotate wheel (J) by hand until
wheel lock lever engages slot in inside flange (S) to lock wheel.
Loosen the bolt (T) counterclockwise in the center of the abrasive
wheel with the included flatwrench (G). Bolt has right-hand
thread.
2. Remove the bolt (T), washer (U), outside flange (V) and old
wheel (J).
3. Make sure flange surfaces are clean and flat. Install the new
abrasive wheel by reversing the above steps.
4. Do not overtighten bolt.
WARNING: Check the work surface that the chop saw rests on
when replacing with a new abrasive wheel. It is possible that the
wheel may contact ANY ITEMS OR STRUCTURE THAT EXTENDS
ABOVE work surface (under the base) when the arm is fully lowered.
FIG. 8
FIG. 7
L
31
J
S V
U
T