10
9
8
48
2
1
Correction
–
Loosen the screws on the control cam 3.
–
Shift the control cam 3 completely to the circlip 4.
–
Tighten the screws on the control cam 3 again.
–
Turn the handwheel until the thread-pulling knife reaches its resting
position.
–
Loosen the lock nut 7.
–
Turn the screw 8 in order to allow a clearance between the roller 9
and the control cam.
–
Tighten the lock nut 7.
–
Loosen screw 6 on the operating lever.
–
Twist the thread-pulling knife 1 so that the marking 2 of the
thread-pulling knife 1 faces the blade of the counter-knife.
7
6
–
Tighten screw 6.
Make sure not to give any end play.
5
4
3