DURKOPP ADLER 867 Service Instructions Manual page 47

Hide thumbs Also See for 867:

Table of Contents

Correction cutting pressure

–

Swing out the thread-pulling knife 1 far enough in a way that the

marking "á" stands close to the blade of the counter-knife 2.

–

Loosen screw 6.

–

Turn the counter-knife 2 against the thread-pulling knife 1.

–

Tighten screw 6.

Note

Through the eccentric cut of the thread-pulling knife 1 a cutting

pressure is automatically exerted when the two blades superpose.

Correction lower thread clamp

–

Swing out the thread-pulling knife 1 far enough in a way that the

marking "á" stands close to the blade of the counter-knife 2.

–

Loosen screw 4.

–

Turn the lower thread clamp 3 to the thread-pulling knife 1.

–

Turn the counter-knife 2 against the thread-pulling knife 1.

–

Fasten screw 4.

Table of Contents