Janome Skyline 55 Instruction Book page 27

q
w
e
Needle stop position setting
The machine always stops with the needle in the down
position except when sewing buttonholes, specialty
stitches such as darning or eyelet, monograms, etc.
However you can select the needle stop position up or
down.
Enter the machine setting mode. Press the mode key to
enter the needle stop position setting.
The default needle stop position setting is down position
"dn".
To change the needle stop position, press the cursor
key " " and the "UP" mark will blink.
Press the set key to exit the machine setting mode.
Start-up speed setting
The machine will start running slowly and the sewing
speed will gradually increase to maximum when pressing
the start/stop button.
You can select the desired start-up speed from 1 (slow) q,
2 (medium) w or 3 (high) e.
Enter the machine setting mode. Press the mode key
twice to enter the start-up speed setting.
The default start-up speed setting is "1" (slow). To change
the start-up speed, press the cursor key "
the selected speed number will blink.
Press the set key to exit the machine setting mode.
Resetting all to default
The following customized settings can be reset to the
default settings (factory settings).
• Buzzer sound
• Needle stop position
q
• Start up speed setting
Enter the machine setting mode. Press the mode key 3
times to enter the Resetting all to default mode.
Press and hold the clear key q until the machine beeps
to reset the machine to the factory default setting.
Press the set key to exit the machine setting mode.
25
" or " ", and