Table of Contents
Advertisement
3 . I N S T A L L A T I O N
3 . 1 I N S T A L L A T I O N
( I ) When installing the receiver on the l9-inch standard rack, place the guide bolt provided
on the side of the chassis on the rails, and push the receiver to the inside of the rack.
Then, flx the receiver in position by screwing the 5-rnm screws through the mounting
holes at two positions of both left and right sides of the front panel.
(2) When installing the receiver on the desk, Llse the special cabinet (optionally available on
separate order).
Attaclt the slide rails (supplied with the cabinet case) onto left and right sides of chassis
of the receiver and mount the receiver in the cabinet case. Fix the receiver to the cabinet
case by screwing the 5-mm screws through four mounting holes on the front panel.
3 . 2 A N T I - I N D U C T I O N O F T H E T R A N S M I T T I N G W A V E
When the receiver is operated with a paired transmitter, it sometimes happens that the
transmitting wave of own station is induced in the receiving antenna.
When the induction current of the transmitting waves is I ampere or less, the receiver is
protected by the built-in input protective circuit. But if the induction current exceeds I
anlpere, the input circuit of the receiver may be burnt out.
When the receiving antenna suf-fers fiom such an excessive induction current, move the
receiving antenna as far as possible trom the transmitting antenna, or insert the anti-inducer
in series betweetr the receiving autenna and antenna input connector as shown in Fig.3.l.
R e c e i v i n g a n t e n n a
l 0 0 v
6 0 w
1 0 0 v
I
6 0 w
I
P L 1 0 1
P L 1 0 2
|
l
/
\
l
i - ç ? ( e }
-{çf-'-_----_--..
a-f
-
#to'
Q
- to tne[Àtrtrlconnecter
r
l
l
l
L _
_ _ J
A W - 0 1
' 1 8
A n t i - i n d u c e r
Fig. 3.1 Protection of the Receiver by the Anti-inducer
3 . 3 C O N N E C T I O N O F E X T E R N A L L I N E S
(l) This receiver is operable in either ACl00tlO% (50/60 Hz) or DC24V!lO%.
For AC operation, conrlect the AC power cable to [nC tO()Vl located on the rear panel
of the nrair-t tratne. For DCI operation, connect the DC power cable MPKCQ|74I
(option) to LO_.9_?4 located on the rear panel of the main frame.
- 6 ,
Advertisement
Table of Contents
