No part of this manual may be reproduced by mechanical, electronic or other means in any form without prior written permission from Acoustic Image. The Acoustic Image logo is a registered trademark of Acoustic Image LLC. Clarus 1, Clarus+ and Cabrio Docking System are trademarks of Acoustic Image LLC.
Voltage Switch BLOW FUSE (F 8A H 250V) 115/230V Fuse All Acoustic Image integrated amplifiers are based on the same superb class-D Headphone power amp that delivers 400-watts into 4 ohms (Clarus 1) or 800-watts into 4 S/N 5F 0001H Output ohms (Clarus+) and on a sophisticated, sensitive preamplifier.
-10 dB MIC ATTEN the push button switch located next to the connector. To avoid an audible “pop”, set the mic input level control all the way off when switching on the phantom power. An LED indicates when phantom power is on. The two channels of the Clarus+ can be blended to mix two instruments, 2 microphones or a mic and an FILTER PHASE INV...
Effects Loop Acoustic Image preamps have output (“Send”) and input (“Return”) capability in each channel to allow you to use effects boxes. The send output is affected by the input volume and tone controls and can also be used as a preamp output for driving other power amplifiers.
(Hall, Room and Plate), a delay, an ambient chorus and a flanger. There are shop or Acoustic Image for more information. A Speakon to 1/4 inch adapter is switches to select which of the two channels are processed by the effects unit.
FAQ section and we post helpful information for getting the most cause undesired operation. out of your Acoustic Image product. Specifications CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s...