Sharp XV-C100A Service Manual page 22

XV-C100A/M/E
No. Adjustment Item
21
On-screen
display position
check (L2003)
22 Temperature
sensor setting
check
23 Component
horizontal
center (NTSC)
(DAC)
24 Component
horizontal
center (PAL)
(DAC)
Adjustment Conditions
1. Receive the NTSC monoscope pattern
signal.
2. Press the SOUND UP/DOWN keys to
get the sound volume display bar on
the screen.
1. Press S2001 to call up the ADJ IN
mode and select the following group.
Group: SET
Subject: HL
1. Receive the NTSC monoscope pattern
signal.
2. Press S2001 to call up the ADJ IN
mode and select the following subject.
Group: VIDEO 4
Subject: C-H-CENT
1. Receive the PAL monoscope pattern
signal.
2. Press S2001 to call up the ADJ IN
mode and select the following subject.
Group: VIDEO 4
Subject: C-PH-CENT
22
Adjustment Procedure
• Turn L2003 so that the display bar
be well centered on the screen.
• Make sure that the setting is 2.
• Using the ' and " keys, make the
overscan just the same at right and
left.
Overscan : 91-97%
• Using the ' and " keys, make the
overscan just the same at right and
left.
Overscan : 91-97%