Advertisement
Thank you for choosing a Mamas & Papas product.
WARNING
_ IMPORTANT: read the instructions carefully before use
and keep them for future reference. The child may be
hurt if you do not follow these instructions.
_ PLIKO SWITCH EASY DRIVE: This item is designed to carry 1
child in the seat.
_ When using the stroller with two children, never leave them
unattended and do not allow the second child to climb onto
the rear ledge if the stroller is empty.
_ Do not use this item for a number of occupants greater than
that intended by the manufacturer.
_ The Pliko Switch Chassis + Pliko Switch seat is approved
for infants from birth up to 15 kg in weight.
_ The Pliko Switch chassis is designed for use with Mamas &
Papas Surefix products: the Pliko Switch chassis + Primo
Viaggio car seat (0+ group) is approved for children from
birth up to 13 kg of weight.
_ Before use check that the Mamas & Papas Surefix products
are correctly fixed to the item.
_ It may be dangerous to leave your child unattended.
_ Always use the 5-point harness and attach the waist strap
to the leg divider strap.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Always apply the brake when stopped and when positioning
the child in the seat or when removing the child from the
seat.
_ Assembly and preparation of the product, plus cleaning and
maintenance operations, must be carried out exclusively by
adults.
_ Do not use this item if there are parts missing or signs of
breakage.
_ Before use check that all the attachment mechanisms are
correctly engaged.
_ Do not insert fingers into the mechanisms.
_ Any load hanging on the handlebar or the handles can make
the stroller/carriage unstable; follow the manufacturer's
instructions for max load capacity.
_ Do not place loads over 5 kilos in the basket. Do not place in
the bottle holder weights heavier than stated or hot drinks.
Do not place in the hood pockets (if applicable) weights over
0.2 Kg.
_ The front bar is not designed to support the child's weight.
It is not designed to keep the child in the seat and does not
substitute for the waist belt.
_ Do not use the item near to stairs or steps, heat sources, naked
flames or dangerous objects within reach of the child.
_ The use of accessories not approved by the manufacturer
could be dangerous.
_ This item is not suitable for jogging or roller skating.
_ Do not use the rain canopy (if present) indoors and regularly
check to ensure the child is not too warm; do not park the
stroller close to heat sources and keep well away from
lighted cigarettes. Ensure the rain canopy is not interfering
with any moving parts of the carriage or stroller; always
remove the rain canopy before folding your carriage or
stroller.
_ When using the stroller with two children, never leave them
unattended and do not allow the second child to climb onto
the rear ledge with the stroller empty.
_ Do not use the release levers to move or lift the stroller
when the child is in it.
_ WARNING: Do not add a mattress pad.
FEATURES OF THE ITEM
_ The item is numbered progressively.
_ Pliko Switch is a stroller with a reversible seat: facing the
person pushing or facing forwards.
_ Pliko Switch is made up of two elements: Pliko Switch
CHASSIS and Pliko Switch SEAT.
COMPONENTS OF THE ITEM
Check the contents of the packaging and if you have any
complaints please contact the Assistance Service.
_ Pliko Switch Chassis: a basket, 2 swiveling or locking front
wheels, 2 rear wheels with a central brake bar and a drink
holder.
_ Pliko Switch Seat: front bar; hood; cover; rain canopy.
INSTRUCTIONS
1 OPENING: Raise the levers on the handlebar together (fig_a)
and pull upwards until the chassis is completely open
(fig_b). Check that the chassis is correctly opened: the side
tubes must be locked together (fig_c). Lastly, slide the two
elements along the handle as shown in the figure (fig_d).
2 Attach the rear wheels to the chassis (fig_a) and
secure them with the screws and nuts. Put the screw
on the outside (on the wheel side) and the nut inside,
then tighten the screw (fig_b).
Attach the central part of the brake bar to the chassis
(fig_c) and check that it has clipped into place
properly (fig_d).
3 FITTING THE BASKET: Slip the loops onto the hooks at the
front (fig_a) and the rear (fig_b).
4 FITTING THE CUP HOLDER: insert the cup holder on the
corresponding peg and press down until it clicks into place
(fig_a). The cup holder can be attached to either side of
the chassis.
5 ADJUSTABLE HANDLEBAR: Pliko Switch Easy Drive: To
adjust the height of the handlebar, press both of the side
buttons at the same time (fig_a) and lock it in the desired
position (fig_b).
6 FIXED OR SWIVELLING FRONT WHEELS: Lift the levers to
prevent the wheels from swiveling (fig_a) and lower them to
allow the wheels to swivel (fig_b). On uneven surfaces, the
wheels should be set to their fixed position.
7 BRAKES: Press a brake lever to immobilize the chassis
(fig_a) and lift the lever to release it (fig_b).
8 MOUNTING THE SEAT TO THE CHASSIS: the reversible seat can
be attached to the chassis either facing the person pushing the
stroller (fig_a), or facing forwards (fig_b), place the seat on the
chassis so that it is aligned with the relative symbols and press
downwards with both hands until you hear two clicks confirming
that it has locked into position. Ensure the seat is correctly
secured by attempting to pull it upwards by gripping the front
bar.
9 REMOVING THE SEAT FROM THE CHASSIS: Hold down the
two round buttons on the sides of the seat (fig_a), press the
two levers under the armrests (fig_b) and pull up the seat
(fig_c) until it is released. The seat can be removed from
and re-attached to the chassis when there is a child in it.
10 FRONT BAR: Before attaching the front bar, press the buttons
on the sides of the armrests and remove the caps (fig_a). To
attach the front bar, guide the connections into the armrests
and push towards the seat until they click into place (fig_b).
To remove the front bar, press the two buttons and pull it out
(fig_c). To make it easier for the child to get in and out, it is
possible to open the front bar on one side only. If you wish to
use the stroller without the front bar, put the caps back in the
armrests.
11 BACKREST: to recline the backrest lift the lever (fig_a) and
choose one of the 4 positions (fig_b).
12 FOOTREST: to lower the footrest push the two levers
downwards and then push the footrest downwards (fig_a);
to raise the footrest lift it upwards (fig_b).
13 FIVE POINT SAFETY HARNESS: To fasten it, push the two
waist strap buckles (with the shoulder straps attached
- 11 -
Advertisement
