Table of Contents
Advertisement
1
2
1. Belt cover
2. Drive belt
3. Cutter cover
4. Side plates
3
1. Guide rule
2. Screwdriver
3. Shiplapping attachment
Side plates
The side plates help to prevent splintering of workpiece. This
tool is equipped with two side plate 21 - 30 (originally
installed on the tool), a side plate 2.4 - 18 (provided as a
standard equipment) and a side plate 33 - 46 (provided as a
standard equipment). Use the correct combination for the
cutter blade to be used. Refer to the table below.
Width of cutter blade to
be used
2.4 - 18 mm
(3/32" - 23/32")
21 - 30 mm
(13/16" - 1-3/16")
33 - 46 mm
(1-5/16" - 1-13/16")
When installing the side plates, adjust them so that the clear-
004829
ances between the side of the cutter blade and the side
plates are approx. 0.1 mm (0.004"). Slowly revolve the cutter
3
blade by turning the drive belt by hand to make sure that the
clearances are adequate. There must be no contact when
rotated.
4
Shiplapping attachment
004830
Use the shiplapping attachment when cutting the edge of the
workpiece. Attach the shiplapping attachment to the guide
rule using the screws.
1
2
Correct combination
On cutter cover side
Side plate 2.4 - 18
Side plate 21 - 30
Side plate 33 - 46
C00105
On belt cover side
Side plate 21 - 30
Side plate 21 - 30
Side plate 21 - 30
9
Advertisement
Table of Contents
