Tile Bezel Feature - KitchenAid KGCP462 Use And Care Manual

The Tile Bezel feature allows you to insert decorative tiles into the bezel assembly. This allows you to coordinate the tiles in the bezel
with the tiles in your kitchen. To order additional Tile Bezels, see "Assistance or Service" section.
1
1. Pre-Bezel Assembly
2. Tile
To Insert Using a in. (10.8 cm) tile
Before inserting the tile, remove tile bezels from accessory box
and unwrap.
1. Remove the piece of square cardboard from inside the bezel
and save.
2. Insert your tile into the bezel with decorative side facing the
front.
3. Depending on the thickness of the tile, use the cardboard or
the foam tape. Either option will require peeling the backing
off the tape and attaching to the tile.
If you are using cardboard, be sure to center on the tile.
4. Reattach assembly to control panel by lining up holes on
back of bezel over screws on the control panel, and push
down firmly until it is in place.

TILE BEZEL FEATURE

2 3
4
3. Cardboard
4. Tile Bezel
5
5. Foam Tape
6. Final Bezel Assembly
To Insert Using a 3 in. (9.8 cm) tile
Before inserting the tile, remove tile bezels from accessory box
and unwrap.
1. Remove the piece of square cardboard from inside the bezel
and save.
2. Peel backing from foam tape and adhere to inside vertical
surfaces of tile bezel.
3. Insert your tile, decorative side facing the front, into one
corner of the bezel and apply some pressure which will
compress the foam tape and allow the other end of the tile to
drop in.
4. Depending on the thickness of the tile, use the cardboard or
the foam tape. Either option will require peeling the backing
off the tape and attaching to the tile.
If you are using the cardboard, be sure to center on the tile.
5. Reattach assembly to control panel by lining up holes on
back of bezel over screws on the control panel, and push
down firmly until it is in place.
6
15