ECS A13G Series User Manual page 31

Motherboard User's Guide
Onboard GPU
Frame Buffer Size
GPU Bank Flip [Disabled]
PMU
CPU Frequency
K8<->NB HT Speed
K8<->NB HT Width
DRAM Configuration
PCIE Spread Spectrum
SATA Spread Spectrum
HT Spread Spectrum
PCIE Clock
SSE/SSE2 Instructions
TPM Control
System BIOS Cacheable
F1: General Help F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults
Timing Mode
This item allows you to set up the DRAM timing nanually or automatically.
Memory Clock value or Limi
When DDR2 Timing Setting by is set to Manual, use this item to set the DRAM
frequency.
DQS Training Control
DQS training is used to place the DQS strobe in the center of the data eye.
CKE base power down mode
When in power down mode, if all pages of the DRAMs associated with a CKE
pin are closed, then these parts are placed in power down mode. Only pre-
charge power down mode is supported, not active power down mode.
CKE based powerdown
The DRAM channel is placed in power down when all chip selects associated
with the channel are idle.
Memclock tri-stating
This item enables or disables memclock tri-stating function.
Memory Hole Remapping
This item allows users to enable or disable memory hole remapping.
Auto Optimize Bottom IO
This item is used to set the Auto Optimized Bottom IO.
Bottom of [31:24] IO space
This item is used to select the memory that will be remapped higher than 00E0.
Bottom of UMA DRAM [31:24]
This item is used to set the bottom of UMA DRAM [31:24]. We strongly
recommend that you leave this item at its default setting.
Phonex-AwardBIOS CMOS Setup Utility
DRAM Configuration
[Enable If No Ext GPU]
[64M]
[Disabled]
[200.0]
[Auto]
[Auto]
[Press Enter]
[Disabled]
[Disabled]
[Disabled]
[100Mhz]
[Enabled]
[No Change]
[Disabled]
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
Help Item
Menu Level
28