The Blade Does Not Rotate; The Appliance Stops As A Result Of An Overload; The Appliance Stops Further To An Overload "Overload; The Appliance Resets While It Is Operating - Santos BRUSHLESS BLENDER 62 User And Maintenance Manual

SANTOS: User and maintenance manual

The blade does not rotate

• Check that there are no foreign bodies stuck in the jar.
• Check the condition of the drive system (motor and blade)
The appliance stops after the motor has overheated, "OVER TEMP": (the motor
unit is hot)
• Put the On / Off switch (4) to the 0 position and unplug the appliance.
• Wait for the motor to cool down (20 to 45 minutes) then press the On / Off switch (4)
(position 1).

The appliance stops as a result of an overload

The LCD screen does not light up
A motor overload can occur if there is an excessive quantity or something too hard in the
jar.
Under these circumstances, either the thermal protection or the excess current protection
may be activated and stop the appliance operating.
If the appliance is hot, refer to the section "The appliance stops as a result of motor over-
heating").
Otherwise:
• Turn off the electric power supply (unplug the mains power cord (10))
• Move the On / Off switch (4) to the 0 position.
• Under the appliance (fig. O), press the button (25) to reset the excess current
protection. If the button does not remain in the "reset" position, allow the appliance to
cool down before repeating the operation.

The appliance stops further to an overload "OVERLOAD":

A motor overload can occur if there is an excessive quantity or
something too hard in the jar.
• The recipe is not appropriate for the quantity and consistency.
• Reduce the quantity.
• Chose a different recipe with slower speeds.

The appliance resets while it is operating:

Eliminate all multiple power sockets and plug the appliance into its own individual power
supply.

Noises, vibrations, leaks at jar blade level

• Check the blade is correctly tightened (first dismantle the blade bearing)
• Replace the bearing seals
See the chapter: "Changing the blade"
If the problem persists, turn the appliance electric power off (unplug the mains power cord
(4)) and call on someone from the maintenance department or contact an approved
SANTOS dealer.
98162 EN 1.5 - 02 2014 16 / 23 www.santos.fr