Fault Finding; The Appliance Will Not Start - Santos BRUSHLESS BLENDER 62 User And Maintenance Manual

SANTOS: User and maintenance manual

FAULT FINDING

Identifying the cause of appliance stoppage with precision.
In all circumstances, if the problem persists, disconnect the electric power supply (unplug
the mains power cord (10)) and call on someone from the maintenance department or
contact an approved SANTOS dealer.

The appliance will not start:

The LCD screen does not light up:
• Check : the mains supply, the condition of the power cord (10).
• Check that the On/Off switch (4) is at position 1
• Check that the ammeter protection system has not been triggered due to an
overload. (see the paragraph:
• Switch the appliance off then on again
• After powering up the 6 key diodes should light up quickly and the screen display
"READY". If not, check on the condition of the wiring and connections in the switch
(4), the component support module and the control panel. (this operation must be
carried out by a qualified person)
The LCD screen shows "NOT READY":
• This message indicates that one of the keys was already
activated before powering up.
• Remove any item liable to activate the keys, clean the control
panel.
The LCD screen shows "LID OPEN":
• Close the safety hood lid (8)
The LCD screen shows "READY":
• Switch the appliance off then on again
• After powering up the 6 key diodes should light up quickly and
the screen display "READY".
• If not, check the connections on the cable connecting the
control panel to the electronic module (this operation must be carried out by a
qualified person).
98162 EN 1.5 - 02 2014
"The appliance stops following a motor
15 / 23
overload")
www.santos.fr